|
WARRANTY & SERVICE
REMINDER |
|
The dive season is just around the corner and will be here before
you know it. With this in mind, our Tech crew Mike, Tom & Dennis
wanted to give you an overview on the annual servicing process of
your equipment and specifically your regulator which is more than
just a simple clean & adjust procedure.
Of course, if your dive equipment is under the U.S. warranty,
this is a must to maintain the warranty.
A special notice:
If you are a diver who dives over 40 or 50 dives a
year……chances are…. YOU may need to consider having your
equipment serviced more than once a year! |
|
Our 21 Point Service performed on your Regulator in our Service
Department
|
|
1. |
We visually inspect your regulator upon
receipt |
| 2. |
We "bench test" you regulator system
prior to servicing for any indication of specific service needs |
| 3. |
We will then contact you if we expect
additional service costs |
| 4. |
We disassemble the first stage of the
regulator |
| 5. |
We clean all metal parts in an
ultra-sonic bath |
| 6. |
We wash and treat all plastic, rubber,
and silicone parts |
| 7. |
We inspect and replace any worn or
damaged parts |
| 8. |
We replace all O-rings and filters |
| 9. |
We disassemble your second stage(s) |
| 10. |
We clean all metal parts in an
ultra-sonic bath |
| 11. |
We wash and treat all plastic, rubber,
and silicone parts |
| 12. |
We inspect your mouthpiece(s) and all
inhalation/exhalation diaphragms |
| 13. |
We check the 2nd stage body for cracks
or damage |
| 14. |
We inspect and replace any worn or
damaged parts |
| 15. |
We inspect all replacement parts prior
to installation |
| 16. |
We reassemble your 1st stage |
| 17. |
We reassemble your 2nd stage(s) |
| 18. |
We assemble the entire system and cycle
it through its operating sequence, a minimum of three times |
| 19. |
We "bench test" your regulator system
adjusting both the 1st stage intermediate pressure and the 2nd stage
cracking pressure |
| 20. |
We then submerge your regulator fully
pressurized for 15 minutes to confirm that there are no leaks and to
ensure valves are properly seated |
| 21. |
We document the bench test results,
complete warranty paperwork if applicable, and package your gear for
pick up including all replaced parts |
| |
|
|
ALL THIS FOR AROUND $60
BUCKS*!
*(not including parts unless
covered if your equipment is under a U.S. Warranty program) This
should be done each year prior to the diving season, before a dive
trip to the islands or anytime you are experiencing
problems with your
equipment!
"Safe Diving & Piece of mind"
|
dive
tech